Common Faults and Routine Maintenance about Label Remover

Recently, several customers are asking how to better maintain the label remover and extend its working life. Today I will give you a summary

Common Faults

1. Malfunction: The spindle does not rotate

Possible causes: damaged V belt at the main motor or damaged bearings;

Solution: Check the pulley and V-belt. If the belt is damaged, replace the belt, or replace the inspection bearing.

2. Malfunction: The machine has a low rate or the product is not clean.

Possible causes: tool wear is severe or tool is damaged.

Solution: Replace the damaged tool.

3. Malfunction: V-belt damaged

Possible causes: Long-term, high-intensity work causes rubber aging

Treatment method: replace the new V belt

Routine maintenance

For the label-remover-machine, if you want to keep good quality and high efficiency, you must carefully maintain it. The maintenance of the label-remover-machine mainly has the following 6 ways.

1. Regularly check if the oil quantity of the lubricating pump oil tank and the base oil tank of the machine is sufficient. Check the reliability of the lubrication system and lubricate the moving parts as required.

2. Regularly check the leakage of the pipe of the machine and the fastening status of the fasteners.

3. Always check if the safety device of the machine is normal and effective, especially after changing the mold. Check whether the mechanical insurance has been adjusted accordingly. Regularly check the ground connection, the insulation of electrical components and the aging of wires.

4 Regularly check the condition of the oil filter or packing, and clean and replace it in time. Always pay attention to if the oil is contaminated and deteriorated. When the hydraulic oil becomes dark brown and emits an odor, it is a sign of oxidative deterioration, and the hydraulic oil should be replaced as soon as possible. When there are small-black-spots or transparent bright spots in the hydraulic oil, it means that impurities or metal powder are mixed in, and it should be filtered or changed.

5. The cooler needs to be soaked and cleaned with carbon tetrachloride solution every 5 to 10 months of operation.

Please contact me if you have any questions. Thanks a lot!