Maintenance of the agglomerator

Recently, a Japanese customer ordered an LTAM-1000 agglomerator. Today I will use this article to talk to you about the daily maintenance of the agglomerator. I hope it can be helpful to you.

1. Definition of plastic agglomerator

LTAM series agglomerator is a kind of recycling equipment, which is used for various soft plastic films, such as PVC, PS, LDPE, HDPE, LLDPE, etc., and bags, wires, belts, sheets, pipe waste and leftovers, then put into reproduction; it can also be used for the recycling and reproduction of degradable plastic film and corner material crushing and granulation; it can also crush and granulate chemical fiber materials (polyester, acrylic, PP, etc.), and put into reproduction waste silk processing. Besides, it can also replace a mixer or dryer.

2. Routine maintenance

In order to ensure the normal operation of the agglomerator, the daily normal use and careful maintenance have a great impact on the service life of the equipment, it is necessary to formulate safe operation procedures and maintenance systems, and carry out regular repairs and replacement parts to prevent incorrect use and operation can cause equipment and personal accidents. The safe operation rules and reasonable maintenance system should be carefully formulated by the user according to the actual situation, and the following precautions should be considered when formulating:

(1) Under normal use of the equipment, the agglomerator must not be used to complete tasks other than those specified in the design, and overload operation is not allowed;

(2) The passage leading to the emergency stop switch should be free of obstructions. Regularly check whether these switches are in good condition;

(3) Always pay attention to the condition of the transmission belt, pay attention to the tension in time, and replace the failed V-belt in time;

(4) Clean up the materials stuck on the surface of the knife and the inner wall of the pot, and clean up in time.

3. Notes

The test run and operation of the machine should be carried out by personnel familiar with the process to prevent accidents, and strictly pay attention to the following matters:

(1) Check whether there is any foreign matter in the pot before starting the machine, if there is, clean it immediately;

(2) Turn on the power supply, start the main motor, and check that the rotary blade rotates clockwise;

(3) Check whether the discharge door is working normally and whether the discharge door can be opened and closed as required;

(4) Technicians must determine in advance the spraying temperature and the amount of spraying water for the materials to be agglomerated;

(5) Before adding materials, the materials must be loosened first, and then gradually added, especially for strips and fibrous materials, which need to be added carefully to avoid entanglement of materials;

(6) When feeding, it should be noted that the short-term load of the motor should not exceed the rated power. When it exceeds, the feeding should be stopped for a while and the material should be loosened and added gradually.

Finally, if this article still doesn’t solve your questions, you will tell me and we will discuss it together. This is my contact information: +86-173 6162 1611, my name is Amy.